Made to Measure

Configure your made to measure display case

Your made to measure display case is based on the proven Sora plug-and-screw system: it is delivered flat-packed and put together in a few minutes – how the plug-and-screw system works.

Width

Depth

Height

Quantity

pcs

Base Back panel

Good to know

Important notes

All measurements are inside dimensions in cm – the inside of the case comes out exactly as you enter it here. The outside dimensions (width +14 mm, depth +8 mm, height +7 mm) are shown by the live calculation as well.
Base “regular” = slip-over version: the base plate has rounded corners and projects at the sides, the case is simply slipped over it. “flush” = exactly rectangular, finishing flush with the case without any overhang.
With a base the usable inside height is reduced: transparent base −4 mm, black base −6 mm (shown in the live calculation as well).
Only one of width and height may be larger than 50 cm – if both are larger, please use the oversize display case. From a width of 110 cm the two-part split display case takes over.
Delivered flat-packed: The made to measure display case is based on the proven Sora plug-and-screw system – it is shipped flat-packed (disassembled) and takes only a few minutes to put together. How that works: the plug-and-screw system explained and the assembly instructions in the next point.
Assembly instructions: PDF download.
No right of withdrawal: Your made to measure display case is manufactured individually to your dimensions. Under Section 312g (2) no. 1 of the German Civil Code (BGB), custom-made items are excluded from the statutory right of withdrawal – exchange or return is therefore not possible. Your statutory warranty rights remain unaffected. More on this: Right of withdrawal.